GE Voluson i BT06 Service Manual page 80

GE
D KTI106052, R
IRECTION
3-4-1 Verify Customer Order and Inspect Components
• Optional: Visually inspect the Modo Cart components using the following checklist.
Table 3-6
b
Step Item
1
Main label
2
Probe Holders
3
Covers
4
Transformer
5
Power Cord
6
Front Castors
7
Rear Castors
Modo Cart
8
Voltage
NOTE: Report any items that are missing, back-ordered, or damaged, to your GE sales representative. The
contact address is shown in
• Optional: Visually inspect the Dock Cart components using the following checklist.
Table 3-7
Step Item
b
1
Main label
2
Probe Holders
3
Covers
4
Transformer
5
Power Cord
6
Front Castors
7
Rear Castors
Dock Cart
8
Voltage
NOTE: Report any items that are missing, back-ordered, or damaged, to your GE sales representative. The
contact address is shown in
3-10
10
EVISION
Damage Inspection Checklist - Modo Cart (optional)
Enter Serial Number: __________________________ (printed on main label)
Clean the gel wells with warm water and a damp cloth to remove all traces of gel.
Check that all screws are in place, all chassis and internal covers are installed.
Check the isolation transformer connectors and the associated cabling for good connection and proper
insulation. Japan only: Exchange pull out protection of main power cord.
Check the power cord for cuts, loose hardware, tire marks, exposed insulation, or any deterioration.
Verify continuity.
Check that the front castors can swivel, and can be placed in the locked position by pressing the foot
brake lever n each castor.
Check that the rear castors can roll and swivel.
Verify that the voltage of the optional Modo Cart is correct.
see: Section 3-4-3 "Modo Cart Voltage Configuration" on page 3-20
Contact Information on page
Damage Inspection Checklist - Dock Cart (optional)
Enter Serial Number: __________________________ (printed on main label)
Clean the gel wells with warm water and a damp cloth to remove all traces of gel.
Check that all screws are in place, all chassis and internal covers are installed.
Check the power supply connectors and the associated cabling for good connection and proper
insulation. Japan only: Exchange pull out protection of main power cord.
Check the power cord for cuts, loose hardware, tire marks, exposed insulation, or any deterioration.
Verify continuity.
Check that the front castors can swivel, and can be placed in the locked position by pressing the foot
brake lever n each castor.
Check that the rear castors can roll and swivel.
Verify that the voltage of the optional Dock Cart is correct.
see: Section 3-4-4 "Dock Cart / Dock Cart light / Voluson Station Voltage Configuration" on page 3-21
Contact Information on page
Section 3-4 - Preparing for Set Up
(cont'd)
Recommended Procedure
1-18.
Recommended Procedure
1-18.
V i / V e
OLUSON OLUSON
S M
ERVICE ANUAL