Mounting Large Peripherals (E.g., Vcr) - GE Voluson i BT06 Service Manual

GE
D KTI106052, R
IRECTION
3-5-3-9

Mounting large Peripherals (e.g., VCR)

1.) Screw out the screws of the leveling feet from the VCR.
2.) Mount the adapter board with the 4 screws on the VCR (leveling feet are also mounted).
NOTE: Pay attention to the right mounting position of the printer.
3.) Put the pre-assembled VCR on the Additional Shelf Peripherals.
4.) Place the locking teeth of the adapter board into the guide slots of the shelf and move the VCR in
the final mounting position.
Figure 3-53 put the pre-assembled VCR on the Shelf / mount the adapter board
5.) Mount the adapter board with 1 screw on the Additional Shelf Peripherals (see
6.) Connect the peripheral device and mount the pull out protection of the power cable.
Links to connection schemes can be found in
3-42
10
EVISION
Figure 3-52 mount the adapter board
Figure 3-54 Connect peripheral device to the Voluson Station
Section 3-5 - Connection of Auxiliary Devices
Table 3-9, "Connection Procedures," on page
Connect B/W printer
or Color printer
Connect Power
Distribution
V i / V e
OLUSON OLUSON
S M
ERVICE ANUAL
Figure 3-53, above).
3-23.