Utility Package (Gx Configurator-Tc); Utility Package Functions - Mitsubishi Electric MELSEC-Q Series User Manual

5 UTILITY PACKAGE (GX Configurator-TC)

5 UTILITY PACKAGE (GX Configurator-TC)

5.1 Utility Package Functions

Table 5.1 Utility Package (GX Configurator-TC) Function List
Function
(1) Configure initial setting for Q62HLC in each channel.
5
Initial setting
(2) The data set the initial setting are registered to the programmable controller CPU parameters,
5 - 1
The following table lists the utility package functions.
Set the values of the items which require the initial setting.
•CH Input range
•CH Sensor compensation value setting
•CH Primary delay digital filter setting
•Cold junction temperature compensation
mode setting
•CH Unused channel setting
•CH Upper setting limiter
•CH Lower setting limiter
•CH Setting change rate limiter
•CH Upper output limiter
•CH Lower output limiter
•CH Output variation limiter
•CH Alert 1 to 4 mode setting
•CH Alert set value 1 to 4
•Alert dead band setting
•Alert delay count
•CH Loop disconnection detection judgment
time
•CH Loop disconnection detection dead
band
•CH Forward/reverse action setting
•CH Control mode
•Approach range setting
•Approach soak time setting
•CH Stop mode setting
•PID continuation flag
•CH AT bias
•CH AT differential gap
•CH AT additional lag
•CH Set value (SV) setting
•CH Proportional band (P) setting
•CH Integral time (I)
and when the programmable controller CPU is set to the RUN mode, they are written
automatically to the Q62HLC.
Description
•CH Derivative time (D)
•CH Control response parameter
•CH Program control run/reset
•CH Execution pattern
•CH Start mode
•CH Time scale
•CH Zone 1 to 7 upper limit
•CH Zone 1 to 8 Proportional band (P)
setting
Integral time (I)
Derivative time (D)
Control response parameter
•CH Program pattern 1 to 3
Final segment
Pattern link
Iteration
Output time of pattern end
Wait zone setting
Segment 1 to 16
Set value (SV) setting
Executing time
Zone PID data No.
•Cascade bias
•Cascade gain
•CH Scaling range upper limit value
•CH Scaling range lower limit value
•CH Scaling width upper limit value
•CH Scaling width lower limit value
MELSEC-Q
Reference
Section 5.4
(To the next page)
5 - 1