Utility Package (Gx Configurator-Ad); Utility Package Functions - Mitsubishi Electric Melsec Q Series User Manual

5

UTILITY PACKAGE (GX Configurator-AD)

5 UTILITY PACKAGE (GX Configurator-AD)

5.1 Utility Package Functions

Table 5.1 Utility package (GX Configurator-AD) function list
Item
1
Initial Setting
5
Auto Refresh
1
Settings
Monitor/test
FB conversion
5 - 1
Table 5.1 shows an overview of the utility package functions.
(1) Sets the following items that require initial setting.
• CH A/D conversion enable/disable setting
• CH Averaging process setting
• CH Time/number of times specifying
• CH Average time/average number of times setting
(2) The data for which initial setting has been completed is registered
in the parameters for the programmable controller CPU, and
automatically written to the A/D converter module when the
programmable controller CPU changes to the RUN status.
(1) Sets auto refresh for the A/D converter module buffer memory.
(2) The buffer memory that was set for auto refresh is automatically
read and written to the specified device when the END command
for the programmable controller CPU is executed.
(1) Monitor/test
The buffer memory and I/O signals for the A/D converter modules
are monitored and tested.
(2) Operating condition setting
Changes the initial setting during operation.
(3) Offset/gain setting
When setting the offset/gain to a value selected by the user (when
the analog output range setting is user range setting), the offset and
gain can be easily set while viewing the screen.
(4) Pass data
The pass data (pass data classification setting, industrial shipment
settings offset/gain values, user range settings offset/gain values)
can be monitored and set.
Generates FB automatically from the intelligent function module
parameter (initial setting/auto refresh setting).
POINT
1 If initial setting and auto refresh setting are performed, the intelligent function
module parameters require a maximum of 76 bytes per module.
Description
MELSEC-Q
Reference section
Section 5.4
Section 5.5
Section 5.6
Section 5.7
5 - 1