Hold Command (Buffer Memory Address 201, 217: Un\G201, Un\G217) - Mitsubishi Electric MELSEC-Q Series User Manual

3 SPECIFICATIONS

3.5.48 Hold command (buffer memory address 201, 217: Un\G201, Un\G217)

Measured value
Hold command
(Buffer memory address: 201, 217)
Hold status flag
(Buffer memory address: 262, 518)
3 - 103
(1) This is the command to pause and restart the program control.
• Hold OFF : Set 0 (default).
When the program control has paused, it restarts from the set
value at the point where it paused.
• Hold ON : Set 1.
The program control pauses and becomes a hold status.
Hold command ON
The program pauses during this period.
0
0
(2) The hold status can be checked in Hold status flag (buffer memory address: 262,
518).
(3) This command is enabled in the program control mode only.
Hold command OFF
1 segment
1
1
MELSEC-Q
Set value
Time
0
0
3 - 103