Movement; Preparation; Moving Method - EBARA EV-SA20 Instruction Manual

P.18

2.3 Movement

・ When using the tool to raise adjuster feet, be careful of handling of the tool.
・ Do not heave the pump.
2.3.1

Preparation

Raise all four adjuster feet fully before moving the pump; otherwise, an obstacle on the floor may
cause the moving pump to tip over.
2.3.2

Moving Method

Move pump slowly by pushing at eyebolt along the long axis of the pump(direction A).
Keep toes and fingers away from moving wheels. If placing the pump in an corner or narrow space
requires moving it along the short axis (Direction B), two persons should "walk" the pump over by
alternately pushing the ends as shown below.
To move the pump across steps, cracks or joints in the floor, spread a steel plate or similar device,
which can sustain the pump weight, over the discontinuity. At least two persons, using great caution,
should move the pump.
If a moving pump should lose balance and start to tip over, do not attempt to stop it. Get away from
the pump immediately.
PM10U
CAUTION
Fully raised
Caster
B
A
Adjuster
Steel Plate
EBARA
CORPORATION