Installation; Movement And Fixation; Location; Caster And Adjustment Foot - EBARA EV-SA20 Instruction Manual

3. Installation

Observe the following cautions and instructions when installing the pump.

3.1 Movement and Fixation

3.1.1

Location

This pump is designed for indoor installation. To install the pump, select a place following
environmental condition. Also allow for sufficient space for convenient pump installation and
maintenance.
Do not install the pump in the environment exposed rain, snow, ice or dust.
Do not install pump in a location where ambient temperature ever exceeds 40 deg C.
Use particular caution when installing the pump in an enclosed room.
Vents at both ends, both side, and top of the pump. Place the pump enough space
from the stationary section. If the cooling air supply is insufficient, the pump
temperature will rise and problems such as rotor contact will occur.
3.1.2

Caster and adjustment foot

Four integral mobile support units consisting of a caster
and a height-adjustment foot each provided underneath
the pump base. To move the pump, raise the four
adjustment feet by turning the holding nuts in the
counter-clockwise direction.
Be careful not to overturn the pump when pushing and pulling it sideways.
The pump is narrow in comparison to its height.
PM10U
Area of use : Indoor Use only
Ambient temperature : 5 to 40 deg C
Humidity : 80% or less (condensation must not exist)
Altitude restriction : Max. 2000m
Pollution : Pollution degree 2
CAUTION
CAUTION
Front / Rear / Top
Both side
WARNING
: 100mm or more
: 50mm or more
Caster
Fig 3.1 Caster and height-adjustment foot
EBARA
P.25
Height-adjustment foot
Approx. 15mm
CORPORATION