EBARA EV-SA20 Instruction Manual page 38

Button
LED
[note 1] If the lamp is turning off, push ESC button several times and turn on.
[note 2] If the lamp is turning on, stop the pump immediately and contact us.
PM10U
Table 4.1 Push button switches on the operation panel
Name
Start the pump.
RUN button
[note] This button works in the LOCAL mode.
Stop the pump.
STOP button
[note] This button works in the both mode LOCAL and REMOTE.
UP/DOWN button Change data screen
ESC button Return the previous menu.
RESET button Reset a fault situation.
LO/RE button Switch between LOCAL and REMOTE.
ENTER button Non-used
Table 4.2 LED Lamp on the operation panel
Lit
Pump is running.
The operation mode is
LOCAL.
Pump is ready.
ALARM condition is
occurred.
During displays the Rotation
-1
speed of the pump [min
Never lit. [note 2]
Flashing
During deceleration to stop
---
---
Minor failure is occurred.
---
]
---
Function
OFF
During stop
The operation mode is
REMOTE.
Pump is not ready.
[note 1]
Normal state (no fault or
alarm)
---
---
EBARA
P.37
CORPORATION