Installation Overview - Comtrol InterChange VS 3000 Series Installation And Configuration Manual

Installation Overview

The following figure illustrates the InterChangeVS 3000 hardware
and software installation procedure.
Note: The following procedure assumes that the ISDN line is already
installed and operational. See the Working with the Phone
Company section for more information.
Connect an RJ45 ISDN* cable between the
VS3000 and ISDN line phone jack or NT1
Terminating Unit (depending on country).
Connect the appropriate Ethernet* cable
To install VS-Link the
first time, use the software
installation section for your
operating system.
While ISDN and Ethernet cables may appear to be identical, they are
*
not interchangeable. Make sure you are using the correct cable(s) in
the correct locations.
Installation Overview
Install the VS3000 using the
Installing the Hardware section.
between the VS3000 and the network.
To update VS-Link or add
additional VS3000 units,
remove the existing VS-Link.
Re-install VS-Link using the
software installation section
for your operating system.
Introduction
9