Configuring Netware Connect (Nwc) - Comtrol InterChange VS 3000 Series Installation And Configuration Manual

Installing VS-Link (Novell)

Configuring NetWare Connect (NWC)

Use the following procedures to configure the VS3000 to run with
NetWare Connect. These instructions assume that you have already:
• Installed at least one ISDN line
• Installed the VS3000 hardware
• Installed the VS-Link software
• Completed the checklist in the Working with the Phone Company
section of this manual
Note: Some of the steps in the following procedure may differ
depending upon your version of NWC. For help, press the
To begin, follow these steps:
1. At the command line prompt, enter:
load nwccon
The NetWare Connect Options menu is displayed:
2. Select Set Up NetWare Connect.
30 Configuring NetWare Connect (NWC)
key.
F1