Table 7. Capi3000 Informational Codes - Comtrol InterChange VS 3000 Series Installation And Configuration Manual

Code
CAPI3000 E821:
CAPI3000 E822:
CAPI3000 E823:

Table 7. CAPI3000 Informational Codes

Code
CAPI3000 I000:
CAPI3000 I001:
CAPI3000 I002:
Table 6. CAPI3000 Error Codes
Message and Description
Unable to output 'set' command to Virtual Server
aaaaaaaa (#dd) on NIC board dd!
A diagnostic set command for VS3000 aaaaaaaa could
not be output via the assigned NIC card dd. The request
is discarded.
Unable to poll Virtual Server aaaaaaaa (#dd) for 'port
status' on NIC board dd!
The periodic 'heartbeat' port status request for VS3000
aaaaaaaa could not be output. This request is discarded,
but another request will be issued shortly.
Unable to find protocol stack for Virtual Server aaaaaaaa
(#dd), NIC dd, status <0xhhhhhhhh>!
The protocol stack constructed during initialization could
not be identified during virtual server FSM initialization.
The vsinit request is discarded.
Message and Description
Comtrol InterChangeVS 3000 ISDN Concentrator
CAPI Driver -
usage:
LOAD CAPI3000
CAPINAME=configurationname
where:
'configurationname' is a configuration file name
example:
LOAD CAPI3000 CAPINAME=VS3000
Enter CAPI3000 ? at the command line prompt to
generate the small help response shown above.
VS3000 aaaaaaaa [00C04E0xyyyy] configured from
'ppppppppaaaaaaaa'.
The VS3000 aaaaaaaa at MAC address 00C04e0xyyyy
will use the configuration file in the subdirectory at
path ppppppppaaaaaaaa.
VS3000 aaaaaaaa [00C04E0xyyyy] firmware load
'ppppppppaaaaaaaa'.
The VS3000 aaaaaaaa at MAC address 00C04e0xyyyy
will use the optional binary file in the subdirectory at
path ppppppppaaaaaaaa.
Error Codes and System Messages
81