Configuring The Wan Call Directory - Comtrol InterChange VS 3000 Series Installation And Configuration Manual

Installing VS-Link (Novell)
c. Enter the directory number in the ISDN Address field.
d. Enter an ISDN Sub-Address, if provided.
e. Select Modem/DCE Type and press Enter. The list of PPP
Modem/DCE Device Types is displayed.
f. Select ISDN(AT Controlled) and press Enter.
g. Set Interface Group, Authentication Options, Timeouts &
Retries, Negotiation Options, Enterprise Specific Traps, and
Physical Options as needed. If unsure of the values to use, keep
the defaults.
h. Press Esc. You are asked if you want to save your changes.
i. Select Yes and press Enter. You are returned to the Network
Interfaces window. The channel should now show a medium of
PPP and a status of Enabled.
j. Repeat this process for each channel on the VS3000.
3. When you are done, press Esc to exit to the Internetworking
Configuration menu.

Configuring the WAN Call Directory

The following procedure is an example of a typical setup. Copy and
adapt this procedure as needed for your installation.
1. From the Internetworking Configuration menu, select WAN Call
Directory.
The list of Configured WAN Call Destinations is displayed.
2. Press the Insert key.
You are prompted to enter a New Call Destination Name.
3. Enter a unique name to identify this destination and press Enter.
You are prompted to choose a supported wide area medium.
4. Select PPP and press Enter.
26 Configuring MultiProtocol Router (MPR)