Table of Contents
Advertisement
7. Press Enter to continue. The Installation Options menu displays.
8. Select Exit and press Enter. The list of Currently Installed
Products is displayed.
9. Press the Esc key until you exit from the install utility.
10. If needed, remove the installation media from the floppy drive.
11. Down and restart the server so that your changes take effect.
Configuring MultiProtocol Router (MPR)
Use the following procedures to configure the VS3000 to run with
MPR 3.1A (or higher) or IntranetWare. These instructions assume
that you have already:
•
Installed at least one ISDN line
•
Installed the VS3000 hardware
•
Installed the VS-Link software
•
Completed the checklist in the Working with the Phone Company
section of this manual
Note: Some steps in the following procedure may differ depending
upon your version of MPR. For help, press the
To begin, follow these steps:
1. At the command line prompt, enter:
load inetcfg
The Internetworking Configuration menu is displayed:
2. Select Boards.
Configuring MultiProtocol Router (MPR)
Installing VS-Link (Novell)
key.
F1
19
Advertisement
Table of Contents
Troubleshooting
