Editing Autoexec.ncf; Selecting Isdn Modem Type - Comtrol InterChange VS 3000 Series Installation And Configuration Manual

Editing AUTOEXEC.NCF

Depending on your current system status and configuration, these
steps may not be necessary:
1. At the command line prompt, enter:
load install
The Installation Options menu is displayed.
2. Select NCF files options.
The Available NCF Files Options menu is displayed.
3. Select Edit AUTOEXEC.NCF file.
4. Scroll through the file, and verify that the following command
appears at or near the end of the file:
nwcstart
5. If the command is in the file, press Alt F10 to exit install.
If the command is not in the file, add it, then press F10 to save the
file and exit to the Available NCF Files Options menu. Press Esc to
exit install.

Selecting ISDN Modem Type

Follow these steps:
1. At the command line prompt, enter:
load nwccon
The NetWare Connect Options menu is displayed.
2. Select Configure NetWare Connect.
The Configuration Options menu is displayed.
3. Select Ports.
The list of configured ports is displayed:
Configuring NetWare Connect (NWC)
Installing VS-Link (Novell)
45