Table of Contents
Advertisement
How to Use this Document
Installation Overview
Default Network Settings
IP address:
192.168.250.250
Subnet mask:
255.255.0.0
Gateway address:
192.168.250.1
Hardware Installation
Hardware Installation
You can use the interactive Table of Contents to locate the information you need.
Red, underscored items are links to URLs. Blue, underscored items are links
within this document or to another document on the media.
Note: If you copy this document from the ftp/web or CD and do not use the
procedure discussed on the CD, you will get an error message when selecting
hyperlinks outside of this document.
The DeviceMaster RTS enables communications with serial devices over an
Ethernet network. The RTS provides for remote management, configuration, and
connectivity through its 10/100BASE–T Ethernet connection.
Use the links below to locate installation procedures for the following models:
Ports
Model Description
DB9 serial port with one
1
Ethernet port
1
Embedded system
DB9 or RJ45 serial ports
4
with two Ethernet† ports
DB9 or RJ45 serial ports
8
with two Ethernet† ports
RJ45 serial ports with two
16
Ethernet† ports
RJ45 serial ports with one
16
Ethernet port
RJ45 serial ports with one
32
Ethernet port
† One of the Ethernet ports on the DeviceMaster RTS 4/8/16 models is a
built-in downstream port for daisy-chaining DeviceMaster systems or
other network-ready devices.
Note: The DeviceMaster Primo is not supported in this document.
Installation Procedure
RTS 1-Port Installation
Appendix A. RTS 1-Port Embedded
System Installation
on Page 33
RTS 4/8-Port Installation
RTS 4/8-Port Installation
RTS 16-Port Installation - External
Power Supply
on Page 8
RTS 16/32RM Installation - Internal
Power Supply
on Page 10
RTS 16/32RM Installation - Internal
Power Supply
on Page 10
on Page 6
on Page 7.
on Page 7
5
Advertisement
Table of Contents
Troubleshooting
