Comtrol InterChange VS 3000 Series Installation And Configuration Manual page 27

The PPP Call Destination Configuration window is displayed:
5. Enter the following information:
Call Type: Select Permanent.
Interface Group: Press Enter to display and select from the list of
defined groups. If no groups are defined, skip this field.
Interface Name: If you did not select an Interface Group, press Enter
to display and select from the list of enabled PPP interfaces (B
channels).
Telephone Number: Enter the destination phone number.
Login Script Name, Retry Mode, Retry Limit Handling, Retry Interval
Limit, Idle Connection Timeout: Use the default values, unless your
application requires different values.
Outbound Authentication: If required, press Enter to display and
select from the list of authentication options.
Password: Enter the outbound authentication password expected
by the remote peer.
Local System ID: The local system server name is displayed. Press
Enter to accept it or enter a different name to use when using this
WAN configuration to place an outbound call.
Remote System ID: Press Enter to display and select from the list of
defined Remote System IDs.
Inbound Authentication Update: Press Enter to accept the default
value of Enabled.
6. Press Esc to exit this window. You are asked if you want to save
your changes.
7. Select Yes and press Enter. The list of Configured WAN Call
Destinations is displayed.
Configuring MultiProtocol Router (MPR)
Installing VS-Link (Novell)
27