Comtrol InterChange VS 3000 Series Installation And Configuration Manual page 38

Installing VS-Link (Novell)
Use the options in this window to enable or disable console logging
of VS3000 status and events.
Note: Some of these options are one-time-only, while others enable
periodic reports that are generated continuously until you
use this window again to disable them. Also, be advised
that some of these options generate substantial amounts of
information and should be used sparingly to avoid affecting
system performance.
For more information on a specific option, use the cursor keys to
highlight the option, press Enter to select it, then press
context-sensitive help.
If all options in this window are set to N, you can press Esc to exit.
If any option in this window is set to Y, you must enter Y in the Exit
option, then press Esc to exit.
15. Press Esc to exit when the Comtrol InterChangeVS 3000
Configuration Utility window is displayed.
You are asked if you want to save the configuration.
16. Select Yes and press Enter.
The WHSMCAPI Board Configuration window is displayed.
If you have selected any diagnostic options, they become effective
immediately. For example, if you have enabled event logging, you
can press Alt Esc to switch to the console and view the event log.
17. Press Esc.
You are asked if you want to save your changes.
18. Select Yes and press Enter.
The Configured Boards window is displayed. It should now show
the VS3000 (under the unique name you gave it in step 7), with the
WHSMCAPI driver, and with a Status of Enabled.
19. Press Esc to return to the Internetworking Configuration menu.
38 Configuring NetWare Connect (NWC)
to display
F1