Configuring Bindings; Exiting From Inetcfg - Comtrol InterChange VS 3000 Series Installation And Configuration Manual

Configuring Bindings

Follow these steps:
1. Select Bindings from the Internetworking Configuration menu.
The list of Protocol To Interface/Group Bindings is displayed.
2. Press the Insert key.
The list of configured protocols is displayed.
3. Select CAPI VS3000 and press Enter.
You are asked to select the interface to which the protocol is bound.
4. Select A Network Interface and press Enter.
You are asked to select a configured network interface.
5. Select the name you assigned to this VS3000 and press Enter.
The Binding a Miscellaneous Protocol to an Interface window is
displayed.
6. If additional bindings are needed, enter the protocol and command
line parameters here. When done, press Esc to close the window.
The list of Protocol to Interface/Group Bindings is displayed.
7. Select IPX and press Enter.
The Binding IPX to a LAN Interface window is displayed.
8. Examine the default parameters and change them if needed.
9. Press Esc to return to the Protocol To Interface/Group Bindings
window.
10. Press Esc to exit to the Internetworking Configuration menu.

Exiting from inetcfg

Changes made in inetcfg do not take effect immediately. To put your
new configuration into effect you must either:
• Select Reinitialize System from the Internetworking Configuration
menu, then press Esc to exit the configuration program.
-OR-
• Press Esc to exit the configuration program, then down and restart
the server.
Note: As a rule, downing and restarting the server is the surest way of
forcing all configuration changes to take effect.
Configuring MultiProtocol Router (MPR)
Installing VS-Link (Novell)
29