Table of Contents
Advertisement
Installing VS-Link (Novell)
Installing VS-Link for Novell
Use the following procedures to install the VS-Link software for
Novell. If updating from an earlier version of VS-Link, make sure that
you remove the existing version first.
These procedures assume that you have already installed the hardware
and determined that it is working properly. For information about the
power-on diagnostics and LED status indicators, see the Installing the
Hardware and Troubleshooting sections.
Note: In a new installation, the lower 10BASE-T LED should be lit (if
using a 10Base-T Ethernet connection) and the PORT 1 B1 light
should be flashing (waiting for the control program to load).
Extracting the Files
If you are installing from the InterChangeVS 3000 Series diskette
supplied with the VS3000 (Part Number: 6620), you do not need to
extract files. Skip to Software Installation, below.
If you have downloaded VS-Link for Novell from the Comtrol ftp site,
you must extract the files and create an installation diskette before
you can install VS-Link. Follow these steps:
1. Copy the download file (6622.zip) to a blank, formatted, diskette.
2. On a DOS or Windows client system, use a utility such as PKUNZIP
or WinZip to extract 6622.zip to the root directory of the diskette.
3. On a DOS client system, use the label a: command to change the
diskette volume label to 6622.
On a Windows client system, use the Properties option to change the
diskette label to 6622.
4. Take the diskette out of the client system drive, label it, and move
to the network server console.
Software Installation
On the network server console, follow these steps:
1. At the command line prompt, enter: load install
The Installation Options menu is displayed.
2. Select Product options.
The Other Installation Actions menu is displayed.
3. Select View/Configure/Remove installed products.
The list of Currently Installed Products is displayed.
16
Installing VS-Link for Novell
Advertisement
Table of Contents
Troubleshooting
