Comtrol InterChange VS 3000 Series Installation And Configuration Manual page 80

Error Codes and System Messages
Code
CAPI3000 E812:
CAPI3000 E813:
CAPI3000 E814:
CAPI3000 E815:
CAPI3000 E816:
CAPI3000 E817:
CAPI3000 E818:
CAPI3000 E819:
CAPI3000 E820:
80
Table 6. CAPI3000 Error Codes
Message and Description
No response to start command from Virtual Server
aaaaaaaa (#dd) on NIC board dd!
After having loaded the VS3000 aaaaaaaa with binary
data, no response was received after activating the
downloaded binary file.
Virtual Server sss...sss (#n) isn't bound, unable to
configure!
Either a CAPI3000 protocol bind was not issued, or a
virtual server ("board") bind wasn't issued, or both.
Configuration error; use inetcfg to adjust board network
interface or bindings configurations and restart server.
Unassigned.
Virtual Server aaaaaaaa (#dd) sent invalid
administrative message type <0xhh>, discarded!
An administrative message was received from VS3000
aaaaaaaa that could not be further identified. The
message is discarded.
Virtual Server aaaaaaaa (#dd) on NIC nn now active!
Not actually an error message. VS3000 aaaaaaaa is now
up and actively responding via NIC card nn.
Unable to output 'start' command to Virtual Server
aaaaaaaa (#dd) on NIC board dd!
A start command to activate the downloaded binary in
VS3000 aaaaaaaa was not output.
Unable to output 'reset' command to Virtual Server
aaaaaaaa (#dd) on NIC board dd!
A reset command for VS3000 aaaaaaaa was not output.
Unable to output 'ID request' command to Virtual Server
aaaaaaaa (#dd) on NIC board dd!
An ID request command for VS3000 aaaaaaaa was not
output.
No buffers available for 'set' command, command
cancelled!
A diagnostic set command for VS3000 aaaaaaaa could
not be output due to too many previous set commands
issued but not yet processed. The request is discarded.