Table of Contents
Advertisement
PPP
To configure your WAN settings for a PPP Configuration, perform the
Configuration
following steps:
Procedure
1 Select Create from the PVC Name Edit Mode drop-down menu. If no
WAN interface has previously been configured, the field will already be
set to Create.
2 Enter a name for your PVC (Permanent Virtual Circuit) in the PVC Name
field. This is the name for the WAN you are configuring. The PVC is the
circuit that will be used to form the connection between the LAN and
WAN sides of the OfficeConnect Gateway.
3 Select the appropriate PPP protocol (PPPoe, PPPoA (LLC-SNAP), or PPPoA
(VC-Mux)) from the WAN Protocol drop-down menu.
4 Select Create New PPP User from the WAN Users Edit Mode drop-down
menu. This should be the default selection. To configure a PPP WAN
connection, you must have a valid PPP User Account with your Service
Configuring PPP-based WANs 6 - 13
Advertisement
Table of Contents
Need help?
Do you have a question about the OfficeConnect 3CR100A97 and is the answer not in the manual?
Questions and answers