Configuring Ppp-Based Wans - 3Com OfficeConnect 3CR100A97 User Manual

6 - 12 C 6: WAN C
HAPTER
Configuring
PPP-based WANs
ONFIGURATION
The following procedure describes how to configure (create) your WAN
settings for the following PPP-based WAN configurations:
PPPoE (Point-to-Point Protocol over Ethernet)
I
PPPoA (LLC-SNAP) (Point-to-Point Protocol over ATM)
I
(with Logical Link Control (LLC) - Sub Network Access Protocol (SNAP)
encapsulation)
PPPoA (VC-Mux) (Point-to-Point Protocol over ATM)
I
with Virtual Circuit Multiplexing (VC-Mux) encapsulation)
A PPP-based WAN Configuration requires a PPP (Point-to-Point) Login
Account (User Name and Password) with your Service Provider. This
information will be provided by your Service Provider.
You can create, modify and delete your PPP WAN Configurations. Refer
to the Modifying Your WAN Protocols section in this chapter for
information on how to modify your currently configured WAN protocols.
If you want to delete a configured WAN protocol, refer to the Deleting
Your WAN Protocols section.
The following illustration shows the WAN Configuration page that is
displayed when a PPP Wan protocol (PPPoe, PPPoA (LLC-SNAP), or PPPoA
(VC-Mux)) is selected in the WAN Protocol drop-down menu. For this
example, PPPoE was selected.