View Advanced Settings; Data Pvcs - 3Com OfficeConnect 3CR100A97 User Manual

11 - 6 C 11: V
HAPTER IEW
View Advanced
Settings

Data PVCs

S
ETTINGS
Metric: Number of routers (1-15) through which data packets travel
I
before reaching their destination. This value represents how far the
route is in hops through other routers. Metric is also referred to as hop
count.
Interface: Interface Type (LAN or WAN).
I
You can view the advanced settings for the following parameters:
Data PVCs
I
Profiles
I
NAT Policies
I
NAT Interfaces
I
VPN Tunnels
I
Tunnel SAs
I
Click Data PVCs to view the Data PVCs page.
The information on this page shows the following information for the
Data PVCs (Permanent Virtual Circuits) currently configured.
Name: The name of your Data PVC.
I
VPI: Virtual Path Identifier. Identifies the virtual path over which the
I
ATM cell should be routed
VCI: Virtual Channel Identifier. Identifies the virtual channel over
I
which the ATM cell should travel
Protocol: The Protocol associated with the Data PVC. (PPP, IP,
I
Unknown)
Peak Cell Rate: This value is set by your Service Provider at the
I
Central Office (CO).
Status: Enabled/Disabled.
I