3Com OfficeConnect 3CR100A97 User Manual page 146

3com officeconnect 3cr100a97 gateway: users guide
Hide thumbs Also See for OfficeConnect 3CR100A97:
Table of Contents

Advertisement

12 - 4
C
12: T
HAPTER
ROUBLESHOOTING
LED
LED State
DSL STATUS
(Link/Data)
(Continued)
PHONE STATUS
LED not lit (green)
(Data and Voice
when Offhook (phone
Base unit only)
is being used).
OfficeConnect Gateway Voice Expansion units
LED
LED State
POWER
LED not lit (green).
EXPANSION
LED not lit (green).
STATUS
Possible Cause
Solution
Ethernet card is
Make sure your
not set up
Ethernet card is set
properly.
up properly (proper
drivers are loaded).
Refer to the
documentation
provided with your
Ethernet card for
instructions.
Phone not
Check that the cable
detected.
for the telephone is
fully plugged into
the correct Phone
connector on the
Base unit.
Possible Cause
Solution
Power not
Check that the
available.
power cable is fully
plugged into an
active power outlet,
and also into the
power inlet on the
rear panel of the
unit.
Base unit not
Check that the
detected or there
Expansion cable is
is no
fully plugged into
synchronization
both the Expansion
with the
unit and the base
OfficeConnect
unit.
Gateway base
If cable is properly
unit.
connected, contact
your Service Provider
or network supplier.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the OfficeConnect 3CR100A97 and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

Ocg voice expansion

Table of Contents