Rfc 1483 Static Configuration - 3Com OfficeConnect 3CR100A97 User Manual

6 - 6 C 6: WAN C
HAPTER
RFC 1483 Static
Configuration
ONFIGURATION
In an RFC-1483 configuration with static IP addressing, the DHCP Client
over WAN setting is disabled. To configure your WAN settings for an RFC
1483 Static Configuration, perform the following steps:
1 Select Create from the PVC Name Edit Mode drop-down menu. If no
WAN interface has previously been configured, the field will already be
set to Create.
2 Enter a name for your PVC (Permanent Virtual Circuit) in the PVC Name
field. This is the name for the WAN you are configuring. The PVC is the
circuit that will be used to form the connection between the LAN and
WAN sides of the OfficeConnect Gateway.
3 Select RFC 1483 from the WAN Protocol drop-down menu.
4 Select Disabled from the DHCP Client Over WAN drop-down menu. The
WAN Configuration page dynamically changes, as shown in the following
illustration, to reflect your selection.
5 Enter the VPI (Virtual Port Identifier) Number that was provided by your
Service Provider in the VPI Number field.