Table of Contents
Advertisement
2 Installation and commissioning
2.5.1 Procedure of assembly
2.5 Assembly of the track
2.5.1 Procedure of assembly
General
The FlexTrack IRT 501 should be assembled as set out in the procedure below.
Detailed descriptions of each stage can be found in the following sections.
Required equipment
Qty
1
1
1
1
1
1
2
2
Qty
3
3
Continues on next page
64
Tool
Ring-open-end spanner 8-22 mm
Socket head cap 2.5 mm, 4 mm, 5 mm, 6 mm, 8 mm and 10 mm
Small flat tip screwdriver
Plastic mallet
Torque wrench 10 Nm -140 Nm
Ratchet head for torque wrench 1/2
Socket head cap 5 mm, 8 mm, 10 mm socket 1/2" bit L 20 mm
Hex head cap 13 mm, 19 mm socket 1/2"bit L 20 mm
Specific FlexTrack tools
Rail Pressing Tool
IRT501-66 & 66R: 3HAW107700358
IRT501-90 & 90R: 3HAW107700456
Rack clamps (3HAW107700357)
© Copyright 20042018 ABB. All rights reserved.
Picture
xx1800001876
xx1800001877
Product manual - FlexTrack IRT501-66/66R/90/90R
3HAW050008590-001 Revision: C
Advertisement
Table of Contents
