Unpacking And Acceptance; Unpacking - ABB FlexTrack IRT501 Series Product Manual

Table of Contents

2.2 Unpacking and acceptance

Inspection

The FlexTrack IRT 501 is wrapped in plastic. Unpack the track and check for any

visible transport damage. If the FlexTrack IRT 501 is damaged, contact ABB.

Contents

If the complete track contains more than 5 modules, it would be separated to more

than 1 sections for packing's convenience. As standard the FlexTrack IRT 501

includes the following on delivery (not including options):

Cleaning

Before transport the FlexTrack IRT 501 has been protected against rust by a thin

film of oil that has been applied before packing. This film of oil must be wiped off

before installation, at the exception of the pre-lubricated parts such as the rack

and the linear guideways.

Product manual - FlexTrack IRT501-66/66R/90/90R

3HAW050008590-001 Revision: C

•

One or more preassembled track sections, depending on the complete track

length. The carriage is mounted on one track section no less than 2 m long.

•

Cable chain. The cable chain has been preassembled on the track when

delivered.

•

Memolub auto lubrication system. The Memolub auto lubrication system has

been installed on the carriage and preset when delivered, but it is not yet

activated.

Note

Wipe off any surplus oil using a lint-free cloth.

2 Installation and commissioning

2.2.1 Unpacking

Table of Contents