How To Read The Product Manual - ABB FlexTrack IRT501 Series Product Manual

Table of Contents

How to read the product manual

Reading the procedures

The procedures contain references to figures, tools, material etc. The references

are read as described below.

References to figures

The procedures often include references to components or attachment points

located on the robot/controller. The components or attachment points are marked

with italic text in the procedures and completed with a reference to the figure where

the current component or attachment point is shown.

The denomination in the procedure for the component or attachment point

corresponds to the denomination in the referenced figure.

The table below shows an example of a reference to a figure from a step in a

procedure.

Reference to required equipment

The procedures often include references to equipment (spare parts, tools etc.)

required for the different actions in the procedure. The equipment is marked with

italic text in the procedures and completed with a reference to the section where

the equipment is listed with further information, i.e. article number, dimension.

The denomination in the procedure for the component or attachment point

corresponds to the denomination in the referenced list.

The table below shows an example of a reference to a list of required equipment,

from a step in a procedure.

Safety information

The manual includes a separate safety chapter that must be read through before

proceeding with any service or installation procedures. All procedures also include

specific safety information when dangerous steps are to be performed.