Table of Contents
Advertisement
3 Maintenance
3.2 Standard toolkit
3.2 Standard toolkit
General
All service (repairs, maintenance and installation) procedures contain lists of tools
required to perform the specified activity. All special tools required are listed directly
in the procedures while all the tools that are considered standard are gathered in
the standard toolkit and defined in the table below. This way, the tools required
are the sum of the standard toolkit and any tools listed in the instruction.
Contents, standard toolkit
Qty
1
1
1
1
1
1
2
2
120
Tool
Ring-open-end spanner 8--22 mm
Socket head cap 2.5 mm, 4 mm, 5 mm, 6 mm, 8 mm and 10 mm
Small flat tip screwdriver
Plastic mallet
Torque wrench 10 Nm-140 Nm
Ratchet head for torque wrench 1/2
Socket head cap 5 mm, 8 mm, 10 mm socket 1/2" bit L 20 mm
Hex head cap 13 mm, 19 mm socket 1/2" bit L 20 mm
© Copyright 20042018 ABB. All rights reserved.
Product manual - FlexTrack IRT501-66/66R/90/90R
3HAW050008590-001 Revision: C
Advertisement
Table of Contents
