If You Use The Cx1104A; Required Accessories; Procedure - Keysight CX3300 Series User Manual

Setting Up the CX3300
Verifying Basic Operation
5. Click the close (x) button located in the upper right corner on the
6. Press the
7. Use the Vertical control knob to adjust the vertical scale. You will see DC
Figure 1-4

If You Use the CX1104A

Required accessories

•
•
•
•
•

Procedure

1. Connect the CX1104A to the Aux Out terminal on the CX3300 front panel by
24
The 2 mA DC current is applied from the Aux Out terminal.
Configuration dialog box to close the dialog box.
key to start waveform acquisition.
Run
current as shown in
Calibration Output
Extension cable, 1 ea., furnished with the CX1104A
Resistive sensor head (CX1211A, CX1212A, CX1213A, CX1214A, CX1215A,
or CX1216A), 1 ea., must be prepared by user
Banana adapter, 1 ea., furnished with the CX1104A
Banana adapter (Banana plug to BNC jack), 1 ea., must be prepared by user
Coaxial cable (BNC plug to BNC plug), 1 ea., furnished with the CX3300
using the accessories listed above.
Do not forget to fasten the screws on the sensor head to assure the contact
with the furnished banana adapter.
Figure 1-4.
Keysight CX3300 User's Guide, Edition 4