Starting And Stopping Waveform Acquisitions - Keysight CX3300 Series User Manual

Starting and Stopping Waveform Acquisitions

Use the Run Control keys or the run control icons to start and stop waveform
acquisitions or make a single acquisition.
The
when the CX3300 is running (acquiring data). The
and the red Stop icon is highlighted when the acquisition is
stopped.
The run control icons and the waveform memory position indicator
are placed above the waveform display area. The position indicator
shows how much of acquisition memory is displayed on the graph.
Waveform expresses all of the memory data. Square surrounds the
data displayed on the graph. Orange vertical line indicates the timebase
position. Moving the square changes data on the graph.
•
•
•
To set up how you want the signals to be sampled, such as sampling rate and
mode, use the Setting dialog box (Setting > Acquisition). This dialog box is
opened by clicking the Setting icon on the sidebar or pressing the
located above the Horizontal control on the front panel.
Keysight CX3300 User's Guide, Edition 4
/ key is lit green and the green Run icon is highlighted
Run Stop
To start waveform acquisition, press the
The CX3300 begins acquiring data. When it receives a trigger signal, it
finishes acquiring data, updates the display, and then starts another
acquisition cycle if it is in Trig'd or Auto trigger mode.
To stop waveform acquisition, press the
The CX3300 stops acquiring data. Whatever data was last acquired remains
on the graph.
To make a single acquisition, press the

Starting and Stopping Waveform Acquisitions

/
Run Stop
/ key or click the Run icon.
Run Stop
/ key or click the Stop icon.
Run Stop
key or click the Single icon.
Single
Using the CX3300
key is red
key
Menu
51