Adjusting The Vertical Scale - Keysight CX3300 Series User Manual

Vertical setup is shown in the Channel summary on the summary bar which is
located bottom of the screen. The summary shows the following information.
•
•
•
•
•
Clicking the Channel summary opens/closes the Channel N mini dialog box used
for quick setup.
Clicking the maximize button in the upper right corner of the mini dialog box
opens the Setting dialog box (Setting > Channels > Channel N) used for detail
setup.

Adjusting the Vertical Scale

•
•
•
•
Keysight CX3300 User's Guide, Edition 4
Vertical scale (A/ or V/, amperes per division or volts per division)
Vertical center value (A or V, amperes or volts), offset from 0 A or 0 V
Sensor setup information (DC, AC, LPF, IF, or blank)
DC: DC coupling
AC: AC coupling
LPF: low pass filter ON
IF: current offset ON
Bandwid th (Hz, hertz), approximate value automatically calculated by
considering the measurement range, the sampling rate, and filters
Measurement range
Summary bar
To make the waveform bigger (fewer amperes per division or fewer volts per
division), turn the vertical scale knob clockwise. To make it smaller (more
amperes per division or more volts per division), turn the knob
counter-clockwise.
Pressing the knob enables or disables the fine mode which provides 1/10
setting resolution.
Double-clicking the vertical scale area on the right or left of the graph opens
the dialog box which allows you to specify the Y-axis scale.
Turning the mouse wheel on the vertical scale area makes the waveform
bigger or smaller.
Adjusting the Vertical Settings
Channel summary
Using the CX3300
55