Quick Start Wizards Via Lui - Siemens SITRANS LUT400 Operating Instructions Manual

Commissioning
6.3 Quick Start Wizards
Other Quick Start Wizards (QSW):
Other Quick Start Wizards using various software packages are also available:
● SIMATIC PDM (HART) (Page 161)
● AMS (HART) (Page 164)
● FC375/475 (HART) (Page 165)
● FDTs (HART) (Page 165)
Before initiating a Quick Start Wizard to configure the device, you may wish to gather the
necessary parameter values. Parameter Configuration Charts that list all parameters and
available options for each application type are available on our website. Go to
www.siemens.com/sitransLUT400 (www.siemens.com/sitransLUT400) > Support >
Application Guides. You can record data and select from options on the chart that apply to
your application, then with this data on hand, complete the Quick Start Wizards via LUI
(Page 58) below, or via another Quick Start Wizard, as referenced above.
6.3.1

Quick Start Wizards via LUI

1. Press
Note
Device continues to measure while in Program Mode. If you wish to disable the device
while it is configured, see Transducer Enable (3.3.1.) (Page 245).
2. Choose Wizards (1.) (Page 168), Quick Start (Page 59), and then the appropriate quick
start: QS Volume (Page 63), QS Flow (Page 67), or Pump Control (Page 74). [The QS
Flow wizard will display on LUI for LUT430 (Pump and Flow), and LUT440 (OCM)
configured models only.]
3. Follow the steps then choose Finish to save Quick Start parameter changes and return to
Program menu, then press
Note
• The Quick Start Wizard settings are inter-related and changes apply only after you
• Perform customization for your application only after the Quick Start has been
58
to enter Program mode.
choose Finish in the final step.
completed.
three times to return to Measurement mode.
Operating Instructions, 07/2019, A5E33329501-AC
SITRANS LUT400