Parameter Reference (Lui) - Siemens SITRANS LUT400 Operating Instructions Manual

Parameter reference (LUI)

Note
• Parameter names and menu structure are almost identical for SIMATIC PDM and the
local user interface (LUI). Access is described below for some parameters that do not
appear in the SIMATIC PDM menu structure. (For further details on using these
parameters within SIMATIC PDM, see the LUT400 Communications manual
• Default settings in the parameter tables are indicated with an asterisk (*) unless explicitly
stated.
• Parameter range values are displayed in the default of the defined unit of measure. For
example, if a parameter description states that it is defined in Units (2.1.1.) (Page 168),
the range for that parameter will be shown in meters [as meters (M) is the default for
Units (2.1.1.) (Page 168)].
• The number of decimals displayed for a parameter value will depend on the unit of
measure, unless decimal places can be set by the user (For example: Totalizers -
Totalizer Decimal Position (2.7.3.2.) (Page 195) 2.7.3.2.Totalizer Decimal Position).
For example:
Values defined in default Units (2.1.1.) (Page 168) will display 3 decimal places; default
Volume Units (2.6.2.) (Page 181) - 1 decimal place, default Flowrate Units (2.15.3.7.)
(Page 233) - 0 decimal places.
• To enter Program mode using the local push buttons, press
Measurement mode.
Communications for SITRANS LUT400 (HART) Manual (7ML19985NE01)
1)
Parameters are identified by name and organized into function groups. See LCD menu
structure (Page 308) for a chart.
Parameters accessible via the local push buttons are preceded by a number. Parameters not
preceded by a number are accessible only via remote operation.
Based on model configuration (LUT420, LUT430, LUT440), some parameters will not appear
on LUI. Exceptions are noted by parameter.
Where the same parameter exists for more than one model, but is represented by a different
menu number, both parameters are listed together (separated by "OR"), and the details are
noted under the second of the two parameters.
For more details see:
● Operation via SIMATIC PDM 6 (HART) (Page 161)
● Operation via AMS Device Manager (HART) (Page 164)
167
. Press
Operating Instructions, 07/2019, A5E33329501-AC
9
.)
1
to return to
SITRANS LUT400