Siemens SITRANS LUT400 Operating Instructions Manual page 92

General Operation
7.2 Relays
On and Off Setpoints
Sets the process point at which the relay is activated (ON setpoint) then reset (OFF
setpoint). These setpoints are set separately for each pump within each pump control, and
for each alarm type:
Function
Pumps (2.7.)
(Page 184)
Modifiers (2.7.2.)
(Page 187)
(for Pumps (2.7.)
(Page 184))
Alarms (2.8.)
(Page 196)
90
Basic Setup (2.7.1.)
(Page 185)
Energy Savings (2.7.2.2.)
(Page 188)
High Level Alarm (2.8.1.)
(Page 196)
Low Level Alarms (2.8.2.)
(Page 197)
In-bounds Level Alarm
(2.8.4.) (Page 199)
Out-of-bounds Level Alarm
(2.8.5.) (Page 200)
Low Temperature Alarm
(2.8.6.) (Page 201)
High Temperature Alarm
(2.8.7.) (Page 202)
High Flowrate Alarm (2.8.9.)
(Page 204)
Low Flowrate Alarm
(2.8.10.) (Page 205)
Parameter
ON Setpoint Pump 1 (2.7.1.6.) (Page 186)
OFF Setpoint Pump 1 (2.7.1.7.) (Page 186)
ON Setpoint Pump 2 (2.7.1.8.) (Page 186)
OFF Setpoint Pump 2 (2.7.1.9.) (Page 186)
Peak ON Setpoint Pump 1 (2.7.2.2.13.)
(Page 192)
Peak OFF Setpoint Pump 1 (2.7.2.2.14.)
(Page 192)
Peak ON Setpoint Pump 2 (2.7.2.2.15.)
(Page 192)
Peak OFF Setpoint Pump 2 (2.7.2.2.16.)
(Page 192)
High Level Value ON (2.8.1.2) (Page 196)
High Level Value OFF (2.8.1.3) (Page 197)
Low Level Value ON (2.8.2.2.) (Page 197)
Low Level Value OFF (2.8.2.3.) (Page 198)
High Level Value (2.8.4.2.) (Page 200)
Low Level Value (2.8.4.3.) (Page 200)
High Level Value (2.8.5.2.) (Page 201)
Low Level Value (2.8.5.3.) (Page 201)
Low Temperature Value ON (2.8.6.2.)
(Page 202)
Low Temperature Value OFF (2.8.6.3.)
(Page 202)
High Temperature Value ON (2.8.7.2.)
(Page 203)
High Temperature Value OFF (2.8.7.3.)
(Page 203)
High Flowrate Value ON (2.8.9.2.) (Page 204)
High Flowrate Value OFF (2.8.9.3.) (Page 205)
Low Flowrate Value ON (2.8.10.2.) (Page 205)
Low Flowrate Value OFF (2.8.10.3.) (Page 206)
Operating Instructions, 07/2019, A5E33329501-AC
SITRANS LUT400