Error Messages While Establishing A Connection - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

Error after disconnecting the battery charger (error on self-test)
Beep Vibration
signal signal
3 x short 3 x short

14.2.3 Error messages while establishing a connection

Error message
DEVICE NOT FOUND
DEVICE DISCONNEC­
TED
Error
Minor error:
e.g. service interval has been
exceeded, disruption of a sensor
signal
Cause
A previously saved con­
nection to the prosthesis
could not be estab­
lished.
A current connection to
the prosthesis was inter­
rupted
Resolution
Contact Ottobock
Correction
Check the following points:
• Distance from the prosthesis to the
remote control
• Battery charge level of the prosthesis
• Active connection with the adjustment
software?
• Bluetooth of the prosthesis switched
on? (see Page 83)
• Prosthesis switched on? (Switching off
the product)
• If multiple prostheses were stored in
the remote control, was the correct
prosthesis selected?
1) Connect the battery charger to the
prosthesis, then charge the battery for
at least 3 hours. You can try to estab­
lish connection again while the battery
is charging.
2) Use the key to confirm the error mes­
sage, then try to establish the connec­
tion again.
3) You will find more information in the
section "Managing prostheses" (see
Page 68).
Check the following points:
• Distance from the prosthesis to the
remote control
• Was the prosthesis connected to anoth­
er remote control?
The connection that was already saved
in the remote control must be deleted in
order to re-connect the prosthesis to
this remote control. A new connection
from the prosthesis to this remote con­
trol must then be established (see
Page 68).
• Use the key to confirm the error mes­
sage, then try to establish the connec­
tion again.
Ottobock | 91