Beep signal
5 x short
4 x short
3 x short
2 x short
1 x short
1 x short
1 x short
Display of current charge level using remote control:
The current charge level is displayed in the status bar of the remote control when it is connected
and switched on:
Display of the current charge level using the remote control app:
Once the remote control app has been started, the current charge level is displayed in the bottom
line of the screen:
7 Remote control
It is possible to switch from basic mode to the pre-configured MyModes using the remote control.
In addition, information about the product (step counter, charge level, etc.) can be called up.
The behaviour of the product can be changed to a certain extent on a day-to-day basis using the
remote control (e.g. while becoming accustomed to the product). At the next appointment, the
prosthetist can trace the changes using the adjustment software.
INFORMATION
The language of the user interface (menus) and the configuration and number of MyModes can
only be changed/adapted using the adjustment software.
INFORMATION
The connection to the original remote control can no longer be established if the product is con
nected to another remote control. As a result, the message "DEVICE DISCONNECTED"
appears in the display of the original remote control when the connection is established.
64 | Ottobock
Vibration signal
3 x long
5 x long
1.
– Charge level of battery for currently connected pros
thesis
– Prosthesis is being charged
2. 68% – Charge level of battery for currently connected pros
thesis, as a percentage
1.
38% – battery charge level of currently connected pros
thesis
Battery charge level
more than 80%
66% to 80%
51% to 65%
36% to 50%
25% to 35%
10% to 24%
5% to 9%