9.2.1 Switching MyModes using the remote control unit
INFORMATION
When the menu option "MODE" has the
unit, it means that MyMode settings cannot be retrieved.
INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the remote control.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down or by
connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. The connection must be established during this period. If required, Bluetooth on the
prosthesis can be switched on permanently afterwards (see Page 83).
Once a connection to a prosthesis has been established, the remote control can be used to
switch between modes.
30
1) Use the
,
keys to select the menu option "MODE" in the main menu and confirm this with
the key.
2) Use the
,
keys to select the mode you want and confirm this with the key.
INFORMATION: If the list of modes was called up accidentally, the active mode can be
selected again.
→ A beep signal sounds to confirm the switch. The message "MODESWITCH SUCCESS
FUL" appears on the remote control unit.
If necessary, switch off the remote control unit by selecting the menu option "RC POWER OFF"
using the
,
keys, and confirm this with the key.
9.2.2 Switching MyModes with the remote control app
INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the remote control.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down or by
connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. The connection must be established during this period. If required, Bluetooth on the
prosthesis can be switched on permanently afterwards (see Page 83).
Once a connection to a prosthesis has been established, the remote control app can be used to
switch between modes.
symbol next to it in the display of the remote control
31
32
Ottobock | 79