The following parameters can be modified:
Parameter
RESISTANCE
STANCE FUNCTION
SITTING FUNCTION
VOLUME
9.3.4 Overview of adjustment parameters in MyModes
The parameters in the MyModes describe the static behaviour of the prosthesis for a specific
motion pattern such as cross-country skiing. Damping behaviour is not automatically controlled
and adjusted in MyModes.
The following parameters can be modified in MyModes:
Parameter
GAIN
VOLUME
9.4 Turning Bluetooth on the prosthesis on/off
INFORMATION
The Bluetooth of the prosthesis must be switched on to use the remote control or remote control
app.
If Bluetooth is switched off, it can be switched on either by rotating the prosthesis or connect
ing/disconnecting the battery charger. Bluetooth is then switched on for approx. 2 minutes. Dur
ing this time, the app must be started and used to establish a connection. If desired, the
Bluetooth of the prosthesis can then be permanently switched on (see Page 83).
9.4.1 Switching Bluetooth on/off using the remote control
1) When a connection is established, use the
the main menu and confirm this with the key.
2) Use the
,
keys to select the menu option "BLUETOOTH". The current status is displayed.
Adjustment
Remote con
software
trol/app
range
adjustment
range
120 to 180
+/- 10
0 to 4
0 to 4
Adjustment
Remote con
software
trol/app
range
adjustment
range
0 to 100
+/- 10
0 to 4
0 to 4
Meaning
Resistance against flexion motion e.g.
when walking down stairs or when sit
ting down
Activation/deactivation of the stance
function. This function needs to be
enabled in the adjustment software.
Further information on the stance
function (see Page 76).
Activation/deactivation of the sitting
function. This function needs to be
enabled in the adjustment software.
Volume of beep signal for confirma
tion tones
Meaning
Value for speed at which flexion resist
ance increases as the knee angle
increases
Volume of beep signal for confirma
tion tones
,
keys to select the "STATUS" menu option in
Ottobock | 83