Charging The Battery; Connecting The Power Supply And Battery Charger - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

Accessories
The following components are not included in the scope of delivery and may be ordered separ­
ately:
• 3S26 cosmetic foam cover
• 4X860=* C-Leg Protector
• AHAB shell incl. shin shield
• 4X78 charger extension cable
• 4X350 remote control
• Remote control app

6 Charging the battery

The following points must be observed when charging the battery:
• The capacity of a fully charged battery is sufficient for one full day.
• We recommend charging the product overnight when used on a daily basis.
• When used daily, the complete charging unit (power supply – battery charger) may remain
plugged into the wall socket.
• The battery should be charged for at least 3 hours prior to initial use.
• Use the 757L16* power supply and 4E50* battery charger to charge the battery.

6.1 Connecting the power supply and battery charger

1) Slide the country-specific plug adapter onto the power supply until it locks into place.
2) Connect the round, three-pin plug of the power supply to the 12V receptacle on the battery
charger so that the plug locks into place.
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
3) Connect the round, four-pin plug of the charging cable to the OUT receptacle on the battery
charger so that the plug locks into place.
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the battery charger.
4) Plug the power supply unit into the wall socket.
→ The green LED on the back of the power supply and the green LED on the battery charger
light up.
→ If the green LED on the power supply and the green LED on the battery charger do not light
up, there is an error (see Page 89).
62 | Ottobock