Error Messages While Establishing A Connection With The Cockpit App; Status Signals - Otto Bock Genium X3 3B5-3 Instructions For Use Manual

Appendices

17.2.3 Error messages while establishing a connection with the cockpit app

Error message
Component was connec­
ted to another device.
Establish connection?
Mode change failed

17.2.4 Status signals

Battery charger connected
LED on Status LED
power sup­ on battery
ply charger
Battery charger disconnected
Beep sig­ Vibration
nal signal
1x short 1x short
54
Cause
The component was connec­
ted to another device
An attempt was made to
switch to a different MyMode
while the component was in
motion (e. g. while walking)
A current connection to the
component was interrupted
Event
Power supply and battery charger operational. Battery charger not yet connected to
receiver.
Battery charger connected to receiver, good connection.
This display turns off automatically after approximately one minute to avoid bother­
some light at night. The charging process is not affected.
Event
Self-test completed successfully. Product
is operational.
Correction
To disconnect the original connection, tap the "OK"
button.
If the original connection is not to be disconnected,
tap the "Cancel" button.
For safety reasons, switching MyModes is only per­
mitted when components are at rest, e. g. while
standing or sitting.
Check the following points:
• Distance from the component to the device
• Charge level of the component's battery
• Bluetooth of the component switched on? ()
• Hold the component with the sole of the foot
facing up to make the component "visible" for
2 minutes.
• If multiple components were stored, was the
correct component selected?
Resolution
Genium X3 3B5-3/3B5-3=ST