•
Before the first step, always check whether the selected mode corresponds to the required
motion type.
Requirements for successful switching using motion patterns
The following points must be observed to carry out switching successfully:
•
Stretch out the prosthetic leg to the back and bounce on the forefoot while maintaining con
tact with the floor.
Switching process
1) While maintaining constant contact with the floor and with the prosthetic leg extended,
bounce on the forefoot at least 3 times but not more than 5 times.
→ A beep signal will sound to confirm that the motion pattern has been recognised.
2) Move the prosthetic leg in next to the contralateral leg, set it down and keep it still for approx.
1 second.
→ A confirmation signal will sound to indicate that the prosthesis has successfully switched over
to basic mode.
INFORMATION: If this confirmation signal does not sound, the leg with the prosthesis
was not correctly repositioned next to the contralateral leg or the requirements were
not observed when bouncing the foot. Repeat the process to correctly switch to the
desired mode.
9.3 Changing prosthesis settings
Once an active connection to a prosthesis has been established, the settings of the MyMode cur
rently active can be changed using the remote control or app.
Information for changing the prosthesis settings
•
Before changing settings, always check the display of the remote control or the remote con
trol app in the main menu to make sure the correct prosthesis has been selected. Otherwise,
parameters could be changed for the wrong prosthesis.
•
It is not possible to change prosthesis settings nor to switch to a different mode while the
prosthesis battery is being charged. Only the status of the prosthesis can be called up.
Instead of the
•
The prosthetist's setting is located in the middle of the scale. After making adjustments, you
can restore this setting by moving the slider control into the middle.
•
Prosthesis settings should be optimised using the adjustment software. The remote control or
app is not intended for use by the prosthetist in order to set up the prosthesis. The behaviour
of the prosthesis can be changed to a certain extent on a day-to-day basis using the remote
control or app (e.g. while becoming accustomed to the prosthesis). The prosthetist can use
the adjustment software to trace these changes at the next appointment.
•
If the settings of a MyMode are to be modified, one must first switch to this MyMode.
9.3.1 Using remote control to change prosthesis settings
33
1) Use the
,
keys to select the menu option "DEVICE SETTINGS" in the main menu and
confirm this with the key.
→ A list appears with the parameters for the currently active mode (see fig. 34).
2) Use the
,
keys to select the parameter you want and confirm this with the
symbol, the
symbol appears in the bottom row of the screen.
34
35
key.
Ottobock | 81