Supported Operating Systems; Control Elements For Remote Control App; Initial Connection Between Remote Control App And Prosthesis - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

8.1.2 Supported operating systems

Install the app only on the following operating systems:
Android from version 4.0.3 (older versions are not supported)

8.2 Control elements for remote control app

8.3 Initial connection between remote control app and prosthesis

The following points should be observed before the initial connection:
• Bluetooth of the component must be switched on.
If Bluetooth is switched off, it can be switched on either by rotating the prosthesis or connect­
ing/disconnecting the battery charger. Bluetooth is then switched on for approx. 2 minutes.
During this time, the app must be started and used to establish a connection. If desired, the
Bluetooth of the prosthesis can then be permanently switched on (see Page 83).
• Bluetooth of the device must be switched on.
The device may not be in flight mode.
• The device must be connected to the internet.
• The serial number of the component you want to connect to is required. For knee joints, this is
located on the inside of the frame and begins with the letters "SN".
72 | Ottobock
1. Product name
The component name can only be changed with the adjust­
ment software.
If connections to a number of prostheses have been saved,
you can switch between the saved prostheses by tapping on
their names.
2. Query status (see Page 73)
3. Bluetooth of the component switched on
Further information about switching Bluetooth off/on see
Page 83.
4. Call up extended menu (see Page 73)
5. Currently selected mode and MyModes configured with the
adjustment software.
Switching the mode by tapping the corresponding symbol
and confirming by tapping "OK".
6. Change settings of the currently selected mode (see
Page 81).
7. Charge level of the component.
Component battery fully charged
Component battery empty
The current charge level is also displayed in %.
8. Connection to component has been established
Connection to component has been interrupted. The app
is attempting to re-establish the connection automatically.
9. Additional display of the currently selected mode