Charging The Prosthesis Battery; Charging The Remote Control Battery; Display Of The Current Charge Level - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

6.2 Charging the prosthesis battery

6.3 Charging the remote control battery

1) Open the charging receptacle cover of the remote control unit.
2) Plug the charging cable into the charging receptacle of the remote control until the plug con­
nector of the charging cable snaps into place.
INFORMATION: Ensure correct polarity (guide lug). Do not use force when connecting
the cable plug to the charging receptacle of the remote control.
3) Plug the power supply into the socket.
→ The charging process starts.
The current charge level of the remote control battery is shown on the display. This symbol
flashes as the battery is charging.
→ The battery is fully charged after approx. three or four hours, after which the symbol in the dis­
play remains permanently lit up.
1) Unplug the charging cable from the charging receptacle.
2) Close the charging receptacle cover.

6.4 Display of the current charge level

1) Open the charging receptacle cover.
2) Connect the charging plug to the charging receptacle of the
product.
INFORMATION: Take note of the plug direction!
→ The correct connection of the battery charger to the product is
indicated by feedback (see Page 92).
3) The charging process starts.
→ Once the product battery is fully charged, the yellow LED on the
battery charger turns off.
4) Disconnect the product after the charging process is complete.
→ This is followed by an electronics self-test which is confirmed by
feedback (see Page 92).
5) Close the charging receptacle cover.
1) Rotate the prosthesis 180° (the sole of the foot must face up).
2) Hold still for 2 seconds and wait for beeps.
Ottobock | 63