Signals For Operating States; Warnings/Error Signals - Otto Bock C-Leg 3C98-3 Instructions For Use Manual

14.2.1 Signals for operating states

Battery charger connected/disconnected
Beep signal
1 x short
none
1 x short
Mode switching
Beep signal Vibration
signal
1 x short 1 x short
1 x short 1 x short
1 x short 1 x short
2 x short 2 x short
3 x short 3 x short

14.2.2 Warnings/error signals

Error during use
Beep signal
10 x 1 sec., then
switching to empty
battery mode
Beep signal
10 x short
30 x long
Vibration signal
none
3 x short
1 x before beep sig­
nal
Additional action per­
formed
Mode switching with the
remote control
Bouncing on the forefoot
Prosthetic leg moved next to
contralateral leg, set down
and kept still for 1 second
Prosthetic leg moved next to
contralateral leg, set down
and kept still for 1 second
Prosthetic leg moved next to
contralateral leg, set down
and kept still for 1 second
Vibration signal
3 x long
5 x long
10 x long
Vibration signal
1 x short at interval of
approx. 5 seconds
10 x for 3 seconds
each
Intermittent for
5 minutes
Event
Battery charger is connected or
battery charger already disconnected prior to
start of charging mode
Charging mode started (3 sec. after connection
of battery charger)
Battery charger disconnected after start of char­
ging mode
Event
Mode switching with the remote
control carried out
Bouncing pattern recognised
Switch to basic mode (mode 1)
carried out.
Switch to MyMode 1 (mode 2)
carried out.
Switch to MyMode 2 (mode 3)
carried out.
Event
Battery charge level under 25%
Battery charge level under 10%
Battery charge level under 5%
Event
Overheated hydraulic
unit
Battery charge level
under 5 %
Severe error
e.g. failure of valve
drives
Possibly no switching
into safety mode.
Required action
Reduce activity
Charge battery
Restricted walking pos­
sible.
Attempt to reset this error
by connecting/discon­
necting the battery char­
ger.
If the error persists, it is
Ottobock | 89