Pairing Of The Remote Control And Battery Change; Pairing; Battery Change - Otto Bock C-Leg Prosthetic System Instructions For Use Manual

Table of Contents

Advertisement

2.10 Pairing of the Remote Control and Battery Change

INFORMATION
Advise your patients of the information in this section.

2.10.1 Pairing

CAUTION
Fault while connecting the C-Leg and remote control (pairing). If several joints are present in close prox-
imity, this can result in unwanted connection of the remote control with another joint (pairing). This can cause the
patient to fall.
Given that only one joint may be paired with a remote control, it must be ensured that no other joint is in the cir-
cumference of 3 m during the pairing.
INFORMATION
If the C-Leg still is in the delivery state, pairing is not required.
Pairing serves to permanently connect a C-Leg to a remote control. Pairing is done
• as soon as a new remote control (replacement) is used with the C-Leg.
• if a configuration or mode switch cannot be effected with fully charged batteries of the joint and the remote con-
trol within the working range of the remote control (70 cm).
For pairing, the following switching procedures with the remote control have been determined:
Performing the pairing (matching the C‑Leg to the remote control)

2.10.2 Battery Change

CAUTION
Impermissible replacement of the battery of the remote control. Replacing the battery on your own initia-
tive can result in defects of the remote control. Malfunction and subsequent unexpected actions of the joint are
then possible. This can cause the patient to fall.
• The battery of the remote control may only be changed by an authorized Ottobock Service Centre.
• To replace the batteries outside of the prescribed service intervals, send the remote control to the authorised
Ottobock Service. Upon receipt of the remote control with a new battery, the remote control must be paired
with the C-Leg (see Section 2.10.1).
22 Ottobock
1 Distance between the remote control and C-Leg: Hold the remote control at
a distance of 30 to 70 cm to the joint.
2 Pairing between the remote control and C-Leg: Briefly press the start button
by poking a thin object (e.g. a paper clip) through the small hole of the remote
control (Fig. 1).
3 Signals: The joint will confirm the successful pairing with 5 short beep signals.
1
C-Leg Prosthetic System

Advertisement

Table of Contents
loading

Table of Contents