MyModes
9.5.2 Status display in the cockpit app
Menu option
Trip: 1747
Step: 1747
Batt.: 68
9.6 Deep sleep mode
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see page 39).
The Cockpit app can be used to place the knee joint into a deep sleep mode, in which power consumption is min
imised. The knee joint offers no functionality in this mode. The safety mode resistance values are activated.
It can be awakened from deep sleep mode with the Cockpit app or by connecting the battery charger.
Deep sleep mode can also be deactivated by activating another MyMode.
9.6.1 Turning deep sleep mode on/off using the Cockpit app
Activating deep sleep mode
Deep sleep mode is displayed like a MyMode and can be activated via the Cockpit app like a MyMode.
Follow the steps in the section "Switching MyModes with the Cockpit app" (see page 42) for switching.
A short beep signal and a short vibration signal indicate that deep sleep mode has been activated.
Deactivating deep sleep mode
To deactivate deep sleep mode, select and activate basic mode or a MyMode in the Cockpit app. Deep sleep
mode ends automatically.
10 MyModes
In addition to basic mode (mode 1), MyModes can be activated and configured with the adjustment software. They
can be called up by the patient using the Cockpit app or movement patterns. Switching by using movement pat
terns has to be activated in the adjustment software.
These modes are intended for specific movement patterns or postures (e.g. inline skating, ...). Default settings for
these movement patterns and postures can be called up and individually adapted using the adjustment software.
Settings can also be adjusted by the patient using the Cockpit app (see page 40).
10.1 Switching MyModes with the cockpit app
INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function only available in
basic mode) or by connecting/disconnecting the battery charger. Bluetooth is then turned on for approx. 2
minutes. During this time, the app must be started and used to establish a connection. If required, Bluetooth on
the prosthesis can be switched on permanently afterwards (see page 41).
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app, there are no beep signals (see page 39).
42
Description
Daily step counter
Total step counter
Current prosthesis charge level, as a
percentage
Possible actions
Reset the counter by tapping the
"Reset" button.
For informational purposes only
For informational purposes only
C-Leg 3C98-3/3C88-3