Running Function As Configured Mymode; Switching Mymodes With The Cockpit App - Otto Bock Genium X3 Instructions For Use Manual

The MyModes are intended for specific movement patterns or postures (e.g. inline skating, run­
ning (jogging) ...). Settings can be adjusted using the cockpit app or remote control (see
Page 33).

9.2.1 Running function as configured MyMode

For running over longer periods of time, the prosthetist can configure a "Run­
ning" MyMode which can be activated using the cockpit app, a movement pat­
tern or the remote control (special accessory).
In this mode, every step will be performed as a running step with larger swing
phase angle and no preflexion at heel strike (PreFlex) (see Page 37).
INFORMATION
The running function will work with specialised running feet such as the 1E90 Sprinter and 1E95
Challenger as well as with prosthetic feet with axial compression such as the 1C61 Triton Vertic­
al Shock. For details on assembly and alignment please refer to the instructions for use of the
foot.
Feet without axial compression are generally not suited for running.

9.2.2 Switching MyModes with the cockpit app

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down or by
connecting/disconnecting the Bluetooth battery charger. Bluetooth is then turned on for approx.
2 minutes. During this time, the app must be started and used to establish a connection. If
required, Bluetooth on the prosthesis can be switched on permanently afterwards (see
Page 34).
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app or using the remote control (see
Page 31) or if mute mode (silent mode) is activated, there are no beep signals.
Once a connection to a prosthesis has been established, the cockpit app can be used to switch
between the MyModes.
28 | Ottobock