Mymodes; Switching Mymodes With The Cockpit App - Otto Bock Genium 3B1-3 Instructions For Use Manual

Hide thumbs Also See for Genium 3B1-3:
Table of Contents

Advertisement

The flexed and partially loaded knee will also disable the stance phase on slopes and ramps to
allow for greater knee flexion and more ground clearance in the swing phase.

9 MyModes

The O&P professional can activate and configure up to five MyModes in addition to basic mode
using adjustment software. These can be selected by using the Cockpit app. Only the first
three MyModes can be selected using movement patterns. Switching by using movement pat­
terns has to be activated in the adjustment software by the O&P professional.
These modes are intended for specific motion patterns or postures (e.g. inline skating...). Set­
tings can be adjusted using the Cockpit app (see page 32).

9.1 Switching MyModes with the cockpit app

INFORMATION
Bluetooth on the prosthesis must be turned on in order to use the Cockpit app.
If Bluetooth is switched off, it can be turned on by turning the prosthesis upside-down (function
only available in basic mode) or by connecting/disconnecting the battery charger. Bluetooth is
then turned on for approx. 2 minutes. During this time, the app must be started and used to
establish a connection. If required, Bluetooth on the prosthesis can be switched on permanently
afterwards (see page 33).
INFORMATION
If the Volume parameter is set to '0' in the Cockpit app (see page 30) or if mute mode (silent
mode) is activated, there are no beep signals.
Once a connection to a prosthesis has been established, the cockpit app can be used to switch
between the MyModes.
36

Advertisement

Table of Contents
loading

This manual is also suitable for:

Genium 3b1-3-st

Table of Contents