Mymodes; Switching Mymodes With The Cockpit App; Basic Mode; Mymode "Training Mode - Otto Bock 17KO1 Series Instructions For Use Manual

MyModes

11 MyModes
For further information about the MyModes and their configuration, see the section "C-Brace Setup adjustment
app" (see Page 80).
The parameters of the MyModes "Training mode" and "Freeze position" are preconfigured and cannot be
changed.

11.1 Switching MyModes with the cockpit app

Once a connection to an orthosis has been established, the Cockpit app can be used to switch between the
MyModes.
Information on switching
• It is always possible to switch back to basic mode by turning the product off and back on (see Page 97) and by
connecting/disconnecting the battery charger.
• Before the first step, always check whether the selected mode corresponds to the required motion type.
• Check whether the battery charger is connected. Changing the mode is not possible when the battery charger
is connected, even though the
• On the device, check whether a connection to the component has been established. The
up.
• On the device, check whether the correct component has been selected.
Switching process
Product

1. Basic Mode

2. Training mode
1
2
4. User defined
3. Freeze position
3
100%
1. Basic Mode
11.2 Basic mode
This mode is intended for daily use.

11.3 MyMode "Training mode"

(if the knee joint is locked during the stance phase and swing phase release is possible)
The knee joint is locked in the stance phase. Swing phase initiation is possible as in basic mode.
In this mode, walking down stairs or a ramp is only possible one step at a time.
100
symbol is lit up.
1) Tap the symbol of the desired MyMode (1) in the main menu of the
Cockpit app.
→ A security question for changing the MyMode appears.
change
2) If you want to change the mode, tap the "OK" button.
→ A beep signal sounds to confirm the switch.
3) After switching, a symbol (2) is displayed to identify the active mode.
→ The current mode is also indicated by the name on the lower edge
of the screen (3).
symbol must be lit
C-Brace joint unit 17KO1=*